| Step | | Procedure & Parts & Tools |
| 1 |
|
PULL THE CHARGER PLUG TO DISCONNECT THE BATTERIES.
|
| 2 |
|
EMPTY THE TANKS AND LAY MACHINE ON ITS SIDE. REMOVE THE SCREW HOLDING THE BOTTOM COVER.
| Screwdriver-phillips |
|
|
| 3 |
|
LOCATE THE RED AND BLACK BRUSH MOTOR WIRES. IF WIRES NEED REPLACED IN THE CONNECTOR BLOCK, LOOSEN THE SCREWS AND PULL THE WIRES OUT. CUT WIRES BACK AND RE-INSERT THEM INTO THE CONNECTOR BLOCK AND TIGHTEN THE SCREWS.
| Screwdriver-flat tip |
|
| Wire cutters |
|
|
| 4 |
|
IF THE WIRES NEED REPLACED OR REPAIRED, CUT BAD SECTION OF WIRE OUT AND SPLICE IN A NEW SECTION.
| Wire crimper |
|
| Wire cutters |
|
|
| 5 |
|
REVERSE STEPS 1 THRU 2 TO REASSEMBLE THE MACHINE.
|